Alpha-nav AN5700NV Manuel d'utilisateur télécharger pdf (Page 51)

3. Select a destination from the list.

4. A full screen map appears with the selected point in the middle. If necessary, tap

the map somewhere else to modify the destination. The Cursor ( ) appears at the

new location. Tap to confirm the destination, or tap

to select a different destination.

5. After a short summary of the route parameters, the map appears showing the entire

route. The route is automatically calculated. Tap to modify route

parameters, or tap and start your journey.

3.1.7 Entering the coordinate of the destination

You can also select a destination by entering its coordinate. Do as follows:

1. If you are on the Map screen, tap to return to the Navigation

menu.

2. In the Navigation menu, tap

3. Open the menu and tap

4. You can enter the latitude and longitude values in any of the following formats:

decimal degrees; degrees and decimal minutes; or degrees, minutes and decimal

seconds.

5. (optional) If necessary, tap then and enter

the coordinate in UTM format

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 87 88

Pas de commentaire

Alpha-nav AN5700NV Manuel d'utilisateur Page 51